HA-2 Pocket-Amplifier for Studio and Practise
Studio Quality :: Sophisticated Sound
Battery Power Supervision Onboard ::
Brushed Aluminium Case
HA-2 is a High-End Amplifier for headphone use which provides sophisticated sound
in a housing out of thick brushed aluminium. Its outstanding sound performance
is achieved through careful circuit design with attention to detail and selection
of finest components available without compromises.
The Amplifier has an
extremely low noise floor and a tube-like dynamic response. The warm and smooth
sound has no discernable hiss even at high level boosting.
input impedance of both instrument inputs is higher than most other bass and guitar
preamps, passive pickups will retain their natural frequency response and tonal
character, as well as piezo ceramic transducers will do.
Outputs act as an unbalanced DI-Out.
Designed for ambitious guitar, bass and
definition amplifier design results in precise and smooth sound reproduction.
precision metal film resistors in the signal path with a resultant noise factor
of up to 10 times lower than standard thick film resistors.
tolerance film capacitors featuring lowest distortion and superior linearity.
compromise quality on active and passive components.
out of brushed aluminium.
After manufacture each
unit undergoes a throughout test and inspection. This ensures each unit passes
strictly quality standards. Serial number is carried out for traceability purposes.
Input Impedance IN1, IN2:
Input Impedance Aux: 47 kOhm
Impedance OUT1, OUT2: 100 kOhm
32 Ohm min.
Frequency Range: 4 Hz to
kHz, -1,5 dB
Supply Voltage:12V via external
wall power supply or 9V battery
Consumption: 16 mA
L 114 x B 70 x H 24 mm
Battery Power Supervision
Reverse Polarity Protection